Released by LINZ under Creative Commons Attribution 4.0 International (CC BY 4.0) with: Following Attribution: "Sourced from the LINZ Data Service and licensed by Marborough District Council for reuse under CC BY 4.0" For details see: https://www.linz.govt.nz/data/licensing-and-using-data/attributing-elevation-or-aerial-imagery-data
Project Aerial photography was captured over the Marlborough urban areas in the Marlborough District totalling approximately 142 km2. The area of capture is located in the Marlborough Region of the South Island.
Data Acquisition The aerial photography for this project was captured within the 2017/18 flying season (September 2017 – April 2018) on the following dates: 1-2 December 2017, 15 December 2017 and 20 December 2017.
Camera: All photography was captured using Vexcel's digital UCE camera and flown at: 0.1 m GSD: 6,309 ft (1,923 m) flying height
Camera Lens: 100 mm
Sun Angle: Minimum of +35 degrees
Flight Planning: SN13944 Marlborough Urban: 54 runs, 891 frames Stereo capture: Forward overlap 60%, min 54%. Side overlap 35%, min 15%.
Environmental Specification: Imagery captured with no cloud or cloud shadow within the area of interest. Tidal restriction for coastal areas captured within 2 hours either side of low tide and priority tidal areas within 1.5 hours either side of high side.
Urban Building Displacement Specification: Urban 0.1 m GSD imagery – using the UCE camera and by flying with 60% forward overlap and with 35% sidelap (standard stereo coverage), maximum 1.1 m building lean per 3 m height within the image model area. To minimise building lean an additional run of 4-5 frames was added to the flight plan along the main street of Blenheim where there is a presence of tall buildings.
Ground Control: A combination of new/existing control and LINZ benchmarks were used for aerial triangulation for this project Twenty-five new post-mark points were obtained by Vince Belgrave of Sounds Surveying.
Data Processing: All aspects of the data processing from imagery processing to DTM creation and ortho production and product deliverables was undertaken in-house by Aerial Surveys staff.
Map Projection All spatial data for this project provided in terms of New Zealand Transverse Mercator 2000 map projection (NZTM2000). The datum is New Zealand Geodetic Datum 2000 (NZGD2000). The height datum is orthometric New Zealand Vertical Datum 2016 (NZVD2016).
Released by LINZ under Creative Commons Attribution 4.0 International (CC BY 4.0) with: Following Attribution: "Sourced from the LINZ Data Service and licensed for reuse under CC BY 4.0" For details see https://www.linz.govt.nz/data/licensing-and-using-data/attributing-linz-data